8/3/2023 0 Comments Ross carbonite solo manual0x4F-Editor Enable 0x52Keyer/MEKey Active Table 8: Supported Buttons NotesBytesME / KeyerName Trying to turn off results in a protocol error.0x00-0x09MEProgram Bus 0-9 0x0BMEAuto Trans DSKs0x0CKeyerKey…Ĩ, Ross CARBONITE GVG10 NotesBytesME / KeyerName 0x4CKeyerKey Self Key 0x4DKeyerKey Auto Key 0x4EKeyerKey Chroma Key Editor control is always enabled. 0x1BMEAspect On Always on trying to turn off…ħ, Ross CARBONITE GVG10 NotesBytesME / KeyerName Trying to turn off results in a protocol error.0x4EKeyer/MEKey Chroma Key Editor control is always enabled Trying to turn off results in a protocol error. DA3MELearn Into Memory Support…Ħ, NotesBytesME / KeyerName 0x0CKeyer/MEKey Auto 0x0DKeyer/MEKey Cut 0x0EMEWipe (transition) 0x0FMEDissolve (transition) Trying to turn off results in a protocol error.0x10-0x19MEPreset Bus 0-9 Trying to turn off results in a protocol error.0x1AMEPreset Bus On-Air Always on trying to turn off results in a protocol error. All buses are selected with 00 for the effects address. Fade to Black = Transition Rate **FD5-*Write Fade to Black Rate Supports memories 0-255. 7D2ME*Read Fade to Black Rate **CC5MEWrite ME Auto Transition Rate **CD5KeyerWrite Keyer Mix Rate *Currently not Supported. Table 5: Supported GVG100 Commands Data / NotesByte CodeLengthME / KeyerName -412ME…ĥ, Data / NotesByte CodeLengthME / KeyerName *Currently ME Specific. Keep the fo…ģ, Table 2: Carbonite Video Source Mapping SourceMap-To Black0 Input BNC 1-241-24 Matte100 Media-Store channels 1-4110-113 Program150 Preview151 Clean Feed152 ME 1 Program155 ME 1 Preview156 ME 1 Clean Feed157 ME 2 Program160 ME 2 Preview161 ME 2 Clean Feed162 MiniME ™ 1210 MiniME ™ 2211 MiniME ™ 3212 MiniME ™ 4213 Table 3: CrossOver ® 12 Video Source Mapping S…Ĥ, SourceMap-To Input BNC 1-41-4 -5 Matte6 Input BNC 5-67-8 Media-Store channels 1-29-10 Program (Aux only)11 Preview (Aux only)12 Clean Feed (Aux only)13 Chroma Key Alpha (Aux only)14 Note: For the following table, ME can be an ME, a MiniME ™, a MultiScreen, or an Aux bus. The exact commands and how the switcher reacts to the commands is outlined in the following tables. Supported GVG100 Commands The switcher supports a number of GVG100 commands. injectGVG100command("0300FB1F") - perform fade to black.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |